HVAC, explained
Typical carbon monoxide levels inside homes
EPA reports that average carbon monoxide levels in homes without gas stoves vary from 0.5 to 5 parts per million (ppm) (EPA). Near properly adjusted gas stoves, levels are often 5 to 15 ppm, and near poorly adjusted stoves they may be 30 ppm or higher (EPA). EPA also notes that no standards for carbon monoxide have been agreed upon for indoor air (EPA).
Knowing what a typical carbon monoxide reading looks like helps you judge a question about your own home. This page gathers the figures and definitions the U.S. Environmental Protection Agency (EPA) publishes on indoor carbon monoxide, including the sources that produce it and the ways to measure it. Each fact names its source so you can check the original EPA pages. The figures below are taken from EPA pages on combustion appliances and indoor air quality (EPA).
What EPA reports as typical levels
Average levels in homes without gas stoves vary from 0.5 to 5 parts per million (ppm) (EPA).
Levels near properly adjusted gas stoves are often 5 to 15 ppm (EPA). Near poorly adjusted stoves, levels may be 30 ppm or higher (EPA).
EPA gives these figures as ranges for homes, and it does not give them as indoor standards (EPA).
Gas stoves and ventilation
EPA says it is most important to be sure combustion equipment is maintained and properly adjusted (EPA). Install and use an exhaust fan vented to outdoors over gas stoves (EPA).
Levels near poorly adjusted stoves may be 30 ppm or higher, compared with the 5 to 15 ppm often seen near properly adjusted stoves (EPA).
Gas stoves are one of the combustion appliances EPA names, alongside furnaces, gas water heaters and gas clothes dryers (EPA).
Outdoor standards are not indoor limits
No standards for CO have been agreed upon for indoor air (EPA). National Ambient Air Quality Standards for outdoor air are 9 ppm for 8 hours and 35 ppm for 1 hour (EPA).
EPA gives those outdoor figures as its National Ambient Air Quality Standards for outdoor air, which is a separate reference from indoor air (EPA).
Where combustion pollutants come from
Combustion appliances include space heaters, gas ranges and ovens, furnaces, gas water heaters, gas clothes dryers, wood or coal-burning stoves, and fireplaces (EPA).
The common fuels burned in these appliances are natural or LP gas, fuel oil, kerosene, wood, or coal (EPA). Carbon monoxide is one of the common pollutants produced from burning these fuels, along with nitrogen dioxide, particles and sulfur dioxide (EPA).
The types and amounts of pollutants depend on the appliance, its installation, maintenance and venting, and its fuel (EPA).
Other indoor combustion sources
Combustion pollutants found indoors include outdoor air, tobacco smoke, and exhaust from car and lawn mower engines (EPA).
Water vapor can result in high humidity and wet surfaces (EPA). High humidity and wet surfaces encourage the growth of house dust mites, molds and bacteria (EPA).
Maintenance and temporary ventilation
Have a trained professional inspect, clean, and tune up central heating systems, including furnaces, flues and chimneys, annually (EPA).
Additional ventilation can be used as a temporary measure when high levels of CO are expected for short periods of time (EPA). Consider purchasing a vented space heater when replacing an unvented one (EPA).
Measuring carbon monoxide at home
Moderately priced real-time measuring devices are also available (EPA). Some relatively high-cost infrared radiation adsorption and electrochemical instruments do exist (EPA).
Compare any reading with the figures above, and note the date and location of each reading before you draw a conclusion.
Summary of the reference figures
Homes without gas stoves: average levels vary from 0.5 to 5 ppm (EPA). Near properly adjusted gas stoves, levels are often 5 to 15 ppm (EPA). Near poorly adjusted gas stoves, levels may be 30 ppm or higher (EPA).
Outdoor air standards are 9 ppm for 8 hours and 35 ppm for 1 hour (EPA). No standards for CO have been agreed upon for indoor air (EPA).
The reference figures show what EPA reports, and the ventilation and maintenance steps above are the measures EPA describes (EPA).
Frequently asked
What is a typical carbon monoxide level in a home?
Average levels in homes without gas stoves vary from 0.5 to 5 parts per million (ppm) (EPA). Levels near properly adjusted gas stoves are often 5 to 15 ppm (EPA). Levels near poorly adjusted gas stoves may be 30 ppm or higher (EPA).
Is there an indoor carbon monoxide standard?
No standards for CO have been agreed upon for indoor air (EPA). National Ambient Air Quality Standards for outdoor air are 9 ppm for 8 hours and 35 ppm for 1 hour (EPA). EPA lists outdoor air, tobacco smoke, and car and lawn mower exhaust among combustion pollutants found indoors (EPA).
Do gas stoves raise carbon monoxide levels?
Levels near properly adjusted gas stoves are often 5 to 15 ppm, and those near poorly adjusted stoves may be 30 ppm or higher (EPA). It is most important to be sure combustion equipment is maintained and properly adjusted (EPA).
Which home appliances produce combustion pollutants?
Combustion appliances include space heaters, gas ranges and ovens, furnaces, gas water heaters, gas clothes dryers, wood or coal-burning stoves, and fireplaces (EPA). Carbon monoxide is one of the common pollutants produced from burning natural or LP gas, fuel oil, kerosene, wood, or coal (EPA).
Can I measure carbon monoxide at home?
Moderately priced real-time measuring devices are also available (EPA). Some relatively high-cost infrared radiation adsorption and electrochemical instruments do exist (EPA). EPA describes these as devices for real-time measurement of CO (EPA).
What helps keep carbon monoxide down?
Install and use an exhaust fan vented to outdoors over gas stoves (EPA). Have a trained professional inspect, clean, and tune up central heating systems annually (EPA). EPA calls additional ventilation a temporary measure for short periods when high CO levels are expected (EPA).
Related
- Radon lung cancer risk for nonsmokers
- Flood drying timeline and how to check dryness
- Indoor Air Quality at Home: How to Monitor It and How to Improve It
Want a licensed check of the gas stove, furnace or water heater in your Florida home? Blume Mechanical Service (CAC-1822618) repairs, installs and maintains HVAC and refrigeration equipment in Pinellas, Hillsborough and Pasco counties. Call 727-330-9131.
Sources: U.S. Environmental Protection Agency (EPA) — What is the average level of carbon monoxide in homes? (https://www.epa.gov/indoor-air-quality-iaq/what-average-level-carbon-monoxide-homes) · U.S. Environmental Protection Agency (EPA) — What are combustion products? (https://www.epa.gov/indoor-air-quality-iaq/what-are-combustion-products)