Blume Mechanical ServiceBlumeMechanical Service

HVAC, explained

Air sealing your home: where to start

In its basement guidance, ENERGY STAR says caulk is best for sealing gaps or cracks that are 1/4 inch or less (ENERGY STAR). ENERGY STAR says spray foam can fill gaps from 1/4 inch to about 3 inches (ENERGY STAR). ENERGY STAR also says it is much easier to seal first to get the full performance out of insulation (ENERGY STAR).

Air sealing is the work of closing gaps, cracks and openings in a home. The sections below draw on several ENERGY STAR pages for a homeowner in the Tampa Bay area. ENERGY STAR says air sealing in the attic is generally a challenging DIY project, but the benefits can be substantial (ENERGY STAR).

Caulk or spray foam, by gap size

Measure the gap before you choose a material. ENERGY STAR says caulk is best for gaps or cracks that are 1/4 inch or less (ENERGY STAR). That sizing, and the spray foam range below, comes from ENERGY STAR's basement guidance.

ENERGY STAR says spray foam can fill gaps from 1/4 inch to about 3 inches (ENERGY STAR). For a gap wider than about 3 inches, ask a licensed contractor how to seal it.

Follow the product label for application.

Basement ceiling penetrations and rim joists

These steps apply only to homes with a basement or crawlspace.

ENERGY STAR recommends sealing penetrations that go through a basement ceiling to the floor above (ENERGY STAR). ENERGY STAR says the top and bottom of the inside of the rim joist cavity should be sealed (ENERGY STAR).

If you use batts at the rim joist, ENERGY STAR says to cut the insulation to fit and place it against the rim joist (ENERGY STAR).

Attic flues, pipes, wires and attic safety

ENERGY STAR says to seal the gap between a furnace or water heater flue and the metal flashing with high-temperature caulk (ENERGY STAR). Check the appliance manual for clearance distances from the flue to combustible material, and ask a licensed contractor when unsure.

ENERGY STAR says to use expanding foam or caulk to seal the openings around plumbing vent pipes and electrical wires (ENERGY STAR).

ENERGY STAR says to walk on joists or truss chords, not on exposed ceiling drywall or insulation, to avoid falling through the ceiling (ENERGY STAR). It also warns to watch for nails pointing up through the ceiling or down from the roof deck (ENERGY STAR).

Duct tape and duct leaks

ENERGY STAR says never to use duct tape for duct sealing, because it is not long-lasting (ENERGY STAR). That rule covers ducts only, not the walls, ceilings or floors of the house.

Florida Solar Energy Center research found that duct leaks cause a significant increase in air conditioning energy use (Florida Solar Energy Center). That finding is about duct leaks, not leaks in walls, ceilings or floors.

Seal before you insulate

ENERGY STAR says it is much easier to seal first to get the full performance out of insulation (ENERGY STAR). Contractors should seal air leaks in the attic floor before adding insulation (ENERGY STAR).

Plan the sealing work before any insulation goes in.

Find the leaks yourself

ENERGY STAR says to find leaks by conducting a simple DIY light test (ENERGY STAR). Where you see light shine through, that spot has an air leak (ENERGY STAR).

For doors and windows, ENERGY STAR describes a paper test: shut the door or window on a piece of paper (ENERGY STAR). If you can pull the paper out without tearing it, you have a leak and you are losing energy (ENERGY STAR).

In a smoke test, ENERGY STAR says that wherever the smoke wavers, or is sucked out of or blown into the room, there is a leak (ENERGY STAR).

ENERGY STAR says to take note of where you see gaps so you can come back and seal them later (ENERGY STAR). It also says the home envelope should be free of gaps and cracks and should be well sealed (ENERGY STAR). ENERGY STAR says it is important that attic insulation be evenly distributed with no low spots (ENERGY STAR).

Blower door test: what it measures

ENERGY STAR says a blower door test measures a home's airtightness and helps locate air leakage paths (ENERGY STAR). A blower door is a powerful fan that mounts into the frame of an exterior door (ENERGY STAR). The fan moves air in or out of the house, changing the air pressure inside to exaggerate air leaks (ENERGY STAR).

Ask an auditor or a licensed contractor to run the test, and ask for a written report of the results.

Ventilation and combustion appliances after sealing

ENERGY STAR says that sealing in some cases can cause naturally venting combustion appliances to backdraft gases back into the home (ENERGY STAR). Before you seal, check which appliances in the home vent naturally, and ask a licensed contractor to assess them.

U.S. EPA says weatherizing without maintaining proper ventilation can negatively affect indoor air (U.S. EPA). Without air ventilation, the humidity level remains high and can provide a breeding ground for mold, mites and bacteria (U.S. EPA).

U.S. EPA also says ventilation is an important part of a building's heating and cooling system because it helps reduce indoor pollutants (U.S. EPA).

Frequently asked

Should I use caulk or spray foam to seal a gap?

In its basement guidance, ENERGY STAR says caulk is best for gaps or cracks that are 1/4 inch or less (ENERGY STAR). ENERGY STAR says spray foam can fill gaps from 1/4 inch to about 3 inches (ENERGY STAR).

What should I seal around plumbing and wires in the attic?

ENERGY STAR says to use expanding foam or caulk to seal the openings around plumbing vent pipes and electrical wires (ENERGY STAR). Check the product label for each material before you use it near wiring.

Can I use duct tape to seal ducts?

No. ENERGY STAR says never to use duct tape for duct sealing, because it is not long-lasting (ENERGY STAR). That rule covers ducts only.

Should I seal air leaks before adding attic insulation?

ENERGY STAR says it is much easier to seal first to get the full performance out of insulation (ENERGY STAR). Plan the sealing work before the insulation goes in.

Can I find air leaks myself?

ENERGY STAR describes DIY checks, and says to find leaks by conducting a simple DIY light test (ENERGY STAR). Where you see light shine through, that spot has an air leak (ENERGY STAR).

Does sealing a house affect indoor air?

U.S. EPA says weatherizing without maintaining proper ventilation can negatively affect indoor air (U.S. EPA). Ask a licensed contractor how much ventilation your home needs.

Related

Need HVAC service? Blume Mechanical Service (CAC-1822618) repairs, installs and maintains HVAC and refrigeration equipment in Pinellas, Hillsborough and Pasco counties. Call 727-330-9131.

Sources: ENERGY STAR (U.S. EPA and DOE) — Sealing Air Leaks: Basement (https://www.energystar.gov/saveathome/seal_insulate/do-it-yourself-guide/sealing-air-leaks-basement) · ENERGY STAR (U.S. EPA and DOE) — Attic Air Sealing Project (https://www.energystar.gov/saveathome/seal_insulate/attic-air-sealing-project) · ENERGY STAR (U.S. EPA and DOE) — Basement & Crawlspace Air Sealing and Insulating Project (https://www.energystar.gov/saveathome/seal_insulate/basement_crawlspace) · ENERGY STAR (U.S. EPA and DOE) — Duct Sealing (https://www.energystar.gov/saveathome/heating-cooling/duct-sealing) · ENERGY STAR (U.S. EPA and DOE) — Well-Insulated and Sealed Attic (https://www.energystar.gov/products/energy_star_home_upgrade/attic_insulation) · ENERGY STAR (U.S. EPA and DOE) — What to Look For: DIY Checks and Inspections (https://www.energystar.gov/saveathome/seal_insulate/identify-problems-you-want-fix/diy-checks-inspections) · ENERGY STAR (U.S. EPA and DOE) — Glossary of Common Terms (https://www.energystar.gov/saveathome/improvements/how-it-works/glossary) · U.S. EPA — Energy, Weatherization and Indoor Air Quality (https://www.epa.gov/indoor-air-quality-iaq/energy-weatherization-and-indoor-air-quality) · Florida Solar Energy Center (University of Central Florida) — FSEC-PF-217-96 (https://www.fsec.ucf.edu/en/publications/html/FSEC-PF-217-96/index.htm)

Search Google for air sealing a florida home