HVAC, explained
Why is my thermostat not turning on?
A blank or unresponsive thermostat screen commonly indicates dead batteries or a tripped circuit breaker (Carrier). Trane says a blank thermostat display indicates no power to the thermostat (Trane). Check the batteries first, then follow the source advice on tripped breakers and wiring (Carrier, Trane).
A thermostat that will not turn on may have a power problem, and the cause can sit in the thermostat, its batteries or the breaker. This page sets out what two equipment makers, Carrier and Trane, say about a dead or unresponsive thermostat. It covers what to check first, why a system can wait before it starts, and when a licensed contractor should take over. Both sources are manufacturer support pages, so each statement describes what that maker says.
What a blank screen usually means
A blank or unresponsive screen commonly indicates dead batteries or a tripped circuit breaker (Carrier). Carrier says that if the display goes completely dark and pressing buttons does nothing, the device has likely lost power (Carrier).
Trane says a blank thermostat display indicates no power to the thermostat (Trane).
The checks below separate the two power causes the sources name, the thermostat's own batteries and the household breaker.
Battery-powered thermostats
If your thermostat runs on batteries, pull the main faceplate off the wall mount and check the battery compartment (Carrier). Carrier says to replace the existing batteries with fresh batteries based on the manufacturer's recommendations (Carrier).
Trane gives the same first step for a battery-powered unit. If the thermostat uses batteries, Trane says to try removing the cover and replacing the batteries (Trane).
Breakers and the HVAC power supply
Trane says the thermostat is connected to the same breaker that supports the HVAC system (Trane).
Trane says a heating or cooling system problem caused the breaker to trip (Trane).
Trane says that if the breaker is tripped, the homeowner should contact an HVAC service provider (Trane). Trane also says flipping a tripped breaker back on and turning on the system could cause damage (Trane).
Ask a licensed HVAC contractor to check the breaker and the wiring when a breaker has tripped.
Wiring and connections
Trane says loose, corroded, or chewed thermostat wiring can cause a thermostat to stop working or work intermittently (Trane). Wiring problems can also show up as a wrong temperature reading.
Trane does not recommend fiddling with the wires unless the homeowner is an HVAC technician or electrician (Trane). Leave the thermostat wires alone unless you have that training.
Carrier says a lack of response between the thermostat and the HVAC equipment could come from several causes. Those include a wiring issue, thermostat failure, control board issue or tripped safety switch (Carrier).
Blume Mechanical Service repairs, installs and maintains HVAC and refrigeration equipment, so a service visit can cover both the thermostat and the equipment it controls.
A clogged filter can shut the system off
Carrier says a heavily clogged air filter restricts airflow, causing internal safety mechanisms to cycle the system off prematurely (Carrier).
Carrier describes the safety shutdown as a way to prevent overheating or freezing (Carrier). A clogged filter is therefore a reason to check the system, not only the thermostat.
Time delays that protect the equipment
Carrier says modern thermostats often have time delays in place to protect equipment from short cycling (Carrier). A delay can make a system look dead for a short time.
Carrier says to wait at least 10 minutes for the system to cycle on when the time delay applies (Carrier).
If the system still does not start after the delay, the cause may lie in the equipment or its controls. Carrier lists those possibilities in its troubleshooting page (Carrier).
When to call a licensed professional
Battery checks are a homeowner step that both Carrier and Trane describe (Carrier, Trane). Breaker and wiring problems are a different matter. Trane says a tripped breaker should go to an HVAC service provider, and it advises against working on the wires without training (Trane).
Carrier lists a control board issue and a tripped safety switch among the causes of a lack of response (Carrier).
If a breaker keeps tripping, call a licensed HVAC contractor rather than repeating resets (Trane).
Frequently asked
What does a blank thermostat screen mean?
Carrier says a blank or unresponsive screen commonly indicates dead batteries or a tripped circuit breaker (Carrier). Trane says a blank thermostat display indicates no power to the thermostat (Trane).
Should I reset the breaker myself?
Trane says that if the breaker is tripped, the homeowner should contact an HVAC service provider (Trane). Trane also says flipping a tripped breaker back on and turning on the system could cause damage (Trane).
Can I replace the thermostat batteries myself?
Yes, if the thermostat uses batteries. Trane says to try removing the cover and replacing the batteries (Trane). Carrier says to use fresh batteries based on the manufacturer's recommendations (Carrier).
Should I touch the thermostat wires?
Trane does not recommend fiddling with the wires unless the homeowner is an HVAC technician or electrician (Trane). Loose, corroded, or chewed wiring can cause a thermostat to stop working (Trane).
Can a heavily clogged filter make the system stop?
Carrier says a heavily clogged air filter restricts airflow, causing internal safety mechanisms to cycle the system off prematurely (Carrier).
Why does my system wait before it starts?
Carrier says modern thermostats often have time delays in place to protect equipment from short cycling (Carrier). Carrier says to wait at least 10 minutes for the system to cycle on when that delay applies (Carrier).
Related
- Is a dehumidifier the same as an air purifier?
- Furnace not blowing hot air: what a contractor checks
- Indoor Air Quality at Home: How to Monitor It and How to Improve It
Need an HVAC check on a thermostat or system that will not turn on in your home? Blume Mechanical Service (license CAC-1822618) repairs, installs and maintains HVAC and refrigeration equipment in Pinellas, Hillsborough and Pasco counties. Call 727-330-9131.
Sources: Carrier — Common Thermostat Issues and How to Troubleshoot (https://www.carrier.com/us/en/residential/hvac-resources/smart-thermostats/common-thermostat-issues.html) · Trane — Thermostat Not Working: Causes and Solutions (https://www.trane.com/residential/en/resources/troubleshooting/thermostat-controls/thermostat-not-working/)