Blume Mechanical ServiceBlumeMechanical Service

HVAC, explained

Ways to heat and cool your home efficiently

Nearly half of the energy used in your home goes to heating and cooling (ENERGY STAR). ENERGY STAR describes steps that change how that system runs, including filter changes, duct sealing and checks on equipment. Sealing air leaks and adding insulation can help your home be more comfortable and energy efficient (ENERGY STAR).

Your heating and cooling system uses a large part of the energy in your home. This page follows the steps ENERGY STAR describes, starting with simple routine checks and moving to larger changes. Each fact names its source. The steps are general guidance from federal sources, so a licensed contractor should check your own system before you buy or change anything.

Change the air filter on a schedule

A dirty filter will slow down air flow and make the system work harder to keep you warm or cool (ENERGY STAR). Check your filter every month, especially during heavy use months, winter and summer (ENERGY STAR). At a minimum, change the filter every 3 months (ENERGY STAR).

A clean filter will also prevent dust and dirt from building up in the system (ENERGY STAR). Check the nameplate or the manual for the filter size your equipment needs before you buy a replacement.

Consider an ENERGY STAR smart thermostat

An ENERGY STAR certified smart thermostat offers more convenience, energy savings, insight, and control than manual or programmable thermostats (ENERGY STAR).

Compare the features of a smart model with the thermostat you have now. Ask your contractor which model is compatible with your heating and cooling equipment before you buy.

Seal the ducts in attics, crawlspaces and garages first

Ducts that move air to and from a forced air furnace, central air conditioner, or heat pump are often big energy wasters (ENERGY STAR).

Focus first on sealing ducts that run through the attic, crawlspace, unheated basement, or garage (ENERGY STAR). Use duct sealant (mastic) or metal-backed foil tape to seal the seams and connections of ducts (ENERGY STAR).

After sealing the ducts in those spaces, wrap them in insulation to keep them from getting hot in the summer or cold in the winter (ENERGY STAR).

Seal air leaks and add insulation

Sealing air leaks around your home and adding insulation can help your home be more comfortable and energy efficient (ENERGY STAR). Simple fixes include installing weather stripping on doors and caulking around windows (ENERGY STAR).

Bigger jobs might include sealing leaks and adding insulation in your attic (ENERGY STAR). Not every insulation is designed for use in every part of the house (ENERGY STAR). Choose the insulation product for each area, and ask the installer which type fits each part of your home.

Check air leaks and ducts before buying new equipment

Before you invest in a new HVAC system, make sure you have addressed the big air leaks in your house and the duct system (ENERGY STAR).

Sometimes these are the real sources of problems rather than your HVAC equipment (ENERGY STAR). Ask your contractor to inspect both areas before you accept a quote for new equipment.

Have older equipment evaluated

If your HVAC equipment is more than 10 years old or not keeping your house comfortable, have it evaluated by a professional HVAC contractor (ENERGY STAR).

If it is not performing efficiently or needs upgrading, consider replacing it with a unit that has earned the ENERGY STAR (ENERGY STAR). Keep the evaluation in writing so you can compare it with any later quotes.

Make sure new equipment is installed correctly

The new equipment must be properly installed (ENERGY STAR). Improper installation can reduce system efficiency, and it can cost more on utility bills and possibly shorten equipment life (ENERGY STAR).

Ask the installer to show you the installation steps in the written quote, and ask how the system will be tested after it is installed. A licensed contractor can answer these questions for the exact equipment in your home.

Questions to ask before you schedule work

Write down the age of your equipment, the age of your filter, and any rooms that stay uncomfortable. The equipment label or the manual shows the model and age details a contractor will ask for. These notes make it easier to compare estimates on the same points. Bring this list to the first visit so the contractor can work from the same facts you have.

Frequently asked

How much of a home's energy goes to heating and cooling?

Nearly half of the energy used in your home goes to heating and cooling (ENERGY STAR). That is a general statement from ENERGY STAR and does not describe any single house. Your own utility bills show how your home uses energy.

How often should I change my air filter?

Check your filter every month, especially during heavy use months, winter and summer (ENERGY STAR). At a minimum, change the filter every 3 months (ENERGY STAR). A dirty filter will slow down air flow and make the system work harder to keep you warm or cool (ENERGY STAR).

Do ducts really waste energy?

Ducts that move air to and from a forced air furnace, central air conditioner, or heat pump are often big energy wasters (ENERGY STAR). ENERGY STAR says to focus first on ducts in the attic, crawlspace, unheated basement, or garage (ENERGY STAR).

Is a smart thermostat worth it?

An ENERGY STAR certified smart thermostat offers more convenience, energy savings, insight, and control than manual or programmable thermostats (ENERGY STAR). Confirm the cost and savings for your home with your utility or a licensed contractor before you buy.

Should I replace equipment or fix air leaks first?

ENERGY STAR advises addressing the big air leaks in your house and the duct system before you invest in a new HVAC system (ENERGY STAR). Sometimes these are the real sources of problems rather than your HVAC equipment (ENERGY STAR).

When should I have my heating and cooling system evaluated?

If your HVAC equipment is more than 10 years old or not keeping your house comfortable, have it evaluated by a professional HVAC contractor (ENERGY STAR). The new equipment must be properly installed (ENERGY STAR).

Related

Need help with the heating and cooling system in your Tampa Bay home? Blume Mechanical Service (license CAC-1822618) repairs, installs and maintains HVAC and refrigeration equipment in Pinellas, Hillsborough and Pasco counties. Call 727-330-9131.

Sources: ENERGY STAR (U.S. EPA and DOE) — Heat & Cool Efficiently (https://www.energystar.gov/saveathome/heating-cooling) · ENERGY STAR (U.S. EPA and DOE) — Seal and Insulate with ENERGY STAR (https://www.energystar.gov/saveathome/seal_insulate)

Search Google for heat and cool home efficiently