HVAC, explained
UV lights in HVAC systems: placement, safety and coils
When designed and installed correctly, UV technology uses UV energy to inactivate microorganisms, including viruses (NIOSH). Airborne viral particles are killed once they receive an appropriate amount of UV energy (NIOSH). UV energy directed or reflected into the occupied space has the potential to cause temporary eye or skin damage (NIOSH). NIOSH recommends upgrading central HVAC filter efficiency to MERV-13 or better (NIOSH).
Germicidal ultraviolet (GUV) systems use ultraviolet lamps installed inside the HVAC system or in special fixtures near the ceiling in occupied rooms (NIOSH). UV lamps can be installed to target problem components such as cooling coils, condensate pans, or filters (ASHRAE). The points below help a Tampa Bay homeowner ask the right questions before a technician installs or services a lamp.
How germicidal UV works in an HVAC system
When designed and installed correctly, UV technology uses UV energy to inactivate microorganisms, including viruses (NIOSH).
Ask the installer how the design delivers an appropriate amount of UV energy.
Ultraviolet germicidal irradiation (UVGI) inactivates pathogens in the air and on surfaces when it is designed properly (University of Illinois). UV-A (315 to 400 nm) is considered safe for occupied spaces but is much less effective at inactivation (University of Illinois).
Where the lamps are placed
UVC devices in air handlers are most often located downstream of the heating and cooling coils (ASHRAE). In room-based layouts, optimal designs place emitters around the room perimeter, and performance is poorest when emitters line one wall (University of Illinois).
Ask the installer how a lamp in either location would be designed and maintained.
Ask why one location was chosen over the other, and ask for the reasoning in writing.
UV and coil cleaning
In commercial and building HVAC design, cooling coil surface treatment is done as an alternative to periodic mechanical and chemical cleaning of coils (ASHRAE). The University of Illinois says cleaning coils through UVGI can decrease pressure drop, mitigating some of the energy from adding UVGI (University of Illinois).
Penn State researchers are studying UV germicidal irradiation as a way to keep HVAC cooling coils clean over the long term (Pennsylvania State University). Penn State field measurements collected temperature, humidity, air flow and pressure drop data on HVAC cooling coils (Pennsylvania State University). Penn State says its field measurements have provided real-world data on the improvements to system performance due to UVGI cleaning (Pennsylvania State University).
Ask the technician how a coil treatment would be measured on your equipment.
Eye and skin safety
UV energy directed or reflected into the occupied space has the potential to cause temporary eye or skin damage (NIOSH). The hazard concerns UV energy that reaches the occupied space (NIOSH).
UV-C in the 200 to 280 nm range cannot be used in occupied spaces, though it can inactivate faster than UV-A designs (University of Illinois). UV lights mounted in a room with a ceiling under 10 feet must have louvers that direct UV radiation away from occupants (University of Illinois).
In-duct UV systems should be fully enclosed and sealed to prevent leakage of UV radiation (ASHRAE). Ask the installer how the fixture is aimed and shielded so that light does not reach living space. If you notice a problem with a lamp or fixture, call the technician who installed it.
Service, lamp life and broken lamps
Maintenance workers should receive special training before working on GUV systems (NIOSH). For in-duct systems, access to lamps should be allowed only when the lamps are de-energized (ASHRAE). Panel and door safety switches should not be the only method used to ensure a UV lamp is de-energized (ASHRAE).
UVC lamps should be replaced at the end of their useful life (ASHRAE). Ask the manufacturer for the rated life of your lamp model.
UVC lamps should be treated in the same manner as other mercury-containing devices, such as fluorescent lamps (ASHRAE). Cleanup of a broken UVC lamp requires special care because of mercury and should be performed by trained workers (ASHRAE).
Filter recommendations from NIOSH
NIOSH recommends upgrading central HVAC filter efficiency to MERV-13 or better (NIOSH). That recommendation is for building ventilation (NIOSH).
Make sure air filters are properly sized and within their recommended service life (NIOSH). Filtration is delivered through central HVAC systems or through portable or built-in room air cleaners (NIOSH).
Ensure ventilation systems operate properly and are up to date on maintenance (NIOSH). This is general advice for building ventilation systems (NIOSH).
Ask a technician to check airflow, the condenser, the evaporator coil and any UV equipment during the same visit.
Frequently asked
Do UV lights in HVAC systems kill viruses?
When designed and installed correctly, UV technology uses UV energy to inactivate microorganisms, including viruses (NIOSH). Airborne viral particles are killed once they receive an appropriate amount of UV energy (NIOSH).
Where are UV lamps placed in an HVAC system?
GUV systems use ultraviolet lamps installed inside the HVAC system or in special fixtures near the ceiling in occupied rooms (NIOSH). UVC devices in air handlers are most often located downstream of the heating and cooling coils (ASHRAE).
Does a blue light on a UV lamp show that it is working?
A blue visible light from a UV lamp does not show that UVC is present (ASHRAE). Ask the installer how the lamp's output is confirmed.
What does NIOSH say about HVAC filters?
NIOSH recommends upgrading central HVAC filter efficiency to MERV-13 or better (NIOSH). Make sure air filters are properly sized and within their recommended service life (NIOSH).
Can UV light harm people in the room?
UV energy directed or reflected into the occupied space has the potential to cause temporary eye or skin damage (NIOSH). UV-C in the 200 to 280 nm range cannot be used in occupied spaces (University of Illinois).
What should I ask a technician about a UV system?
Ask whether the system was designed for the space it serves. Upper-room GUV systems are generally custom designed for the space in which they will be used (NIOSH). In-duct systems should be fully enclosed and sealed to prevent leakage of UV radiation (ASHRAE), so ask the installer to show how that is done.
Related
- Electrostatic air filters and electronic air cleaners
- Ozone generators sold as air cleaners: EPA and CARB facts
- Mold in HVAC Systems: Why Florida Humidity Makes It Common
Thinking about a UV lamp or a filter upgrade for your HVAC system? Blume Mechanical Service (license CAC-1822618) repairs, installs and maintains HVAC equipment in Pinellas, Hillsborough and Pasco counties. Blume is brand-agnostic. Call 727-330-9131.
Sources: Centers for Disease Control and Prevention (NIOSH) — About Germicidal Ultraviolet (GUV) (https://www.cdc.gov/niosh/ventilation/germicidal-ultraviolet/) · Centers for Disease Control and Prevention (NIOSH) — Improving Air Cleanliness (https://www.cdc.gov/niosh/ventilation/prevention/air-cleanliness.html) · University of Illinois — Ultraviolet Germicidal Irradiation (UVGI) (https://energysense.uillinois.edu/ultraviolet-germicidal-irradiation-uvgi/) · ASHRAE — Chapter 62. Ultraviolet Air and Surface Treatment (https://handbook.ashrae.org/Handbooks/A19/SI/a19_ch62/a19_ch62_si.aspx) · ASHRAE — Chapter 60. Ultraviolet Air and Surface Treatment (https://handbook.ashrae.org/Handbooks/A15/SI/A15_CH60/a15_ch60_si.aspx) · Pennsylvania State University — Research aims to measure benefits of using UV light as an HVAC coil cleaner (https://www.psu.edu/news/research/story/research-aims-measure-benefits-using-uv-light-hvac-coil-cleaner)