Blume Mechanical ServiceBlumeMechanical Service

HVAC, explained

Mold versus mildew: what EPA says about the difference

Mildew refers to certain kinds of mold or fungus (EPA). The key to mold control is moisture control (EPA). EPA says it is important to dry water-damaged areas and items within 24-48 hours to prevent mold growth (EPA).

Homeowners often hear mold and mildew used as if they mean the same thing. This page sets out what EPA says about the two words, where each one tends to appear, and which moisture steps EPA recommends. Each section below covers one topic, from the names to the moisture steps. Each sentence below names its source in parentheses, so you can check the wording against EPA's pages.

What the two words mean

Molds include all species of microscopic fungi that grow in the form of multicellular filaments, called hyphae (EPA). The term mildew is often used generically to refer to mold growth, usually with a flat growth habit (EPA). Mildew is one name for certain kinds of mold, and molds are microscopic fungi (EPA). EPA notes that mildew is often used generically for mold growth (EPA). Molds reproduce by tiny spores that are invisible to the naked eye and float through outdoor and indoor air (EPA). There are many types of mold, and none of them will grow without water or moisture (EPA).

Where mildew and mold show up

Mildew often lives on shower walls, windowsills, and other places where moisture levels are high (EPA). Molds can thrive on any organic matter, including clothing, leather, paper, and the ceilings, walls and floors of homes with moisture management problems (EPA). In unaired places such as basements, mold and mildew can produce a strong musty odor (EPA). Mold spores float through indoor air and land on surfaces (EPA). The places above are common examples, not a full list of where mold can grow. Outdoors, molds break down dead organic matter such as fallen leaves and dead trees (EPA). Indoors, mold growth should be avoided (EPA).

Moisture is the common factor

Mold may begin growing indoors when mold spores land on surfaces that are wet (EPA). The mold spores will not grow if moisture is not present (EPA). Places that are often or always damp can be hard to maintain completely free of mold (EPA). Moisture is the thread that links the rest of the points on this page.

Acting within 24-48 hours

The timing below comes straight from EPA's wording. Water-damaged areas should be dried within 24-48 hours (EPA). Drying within 24-48 hours is listed by EPA as a way to prevent mold growth (EPA). It is important to dry water-damaged areas and items within 24-48 hours to prevent mold growth (EPA). If you clean up the mold but do not fix the water problem, the mold problem will most likely come back (EPA). It is impossible to get rid of all mold and mold spores indoors (EPA). Some mold spores will be found floating through the air and in house dust (EPA). There is no practical way to eliminate all mold and mold spores in the indoor environment (EPA).

Health effects EPA lists

Potential health effects and symptoms associated with mold exposures include allergic reactions, asthma, and other respiratory complaints (EPA). Inhaling or touching mold or mold spores may cause allergic reactions in sensitive individuals (EPA). Molds produce allergens, irritants, and in some cases, potentially toxic substances (mycotoxins) (EPA). Molds gradually destroy the things they grow on (EPA). These points are general; a health professional can advise on a specific person's symptoms.

Humidity and ventilation

EPA lists using air conditioners and de-humidifiers among the ways to reduce indoor humidity (EPA). EPA says increasing ventilation helps reduce indoor humidity (EPA). EPA says to vent bathrooms and dryers to the outside to reduce indoor humidity (EPA). EPA says to use exhaust fans whenever cooking, dishwashing, and cleaning (EPA). EPA says to keep indoor humidity low where possible (EPA). EPA's full list of methods is on its mold pages, so read it there before buying equipment.

Air conditioning and HVAC

EPA says to keep air conditioning drip pans clean and the drain lines unobstructed and flowing properly (EPA). EPA says not to run the HVAC system if you know or suspect that it is contaminated with mold (EPA). The HVAC system could spread mold throughout the building (EPA). A licensed HVAC technician can inspect the equipment before anyone runs it again.

Frequently asked

Is mildew a different thing from mold?

Mildew refers to certain kinds of mold or fungus (EPA). The term mildew is often used generically to refer to mold growth, usually with a flat growth habit (EPA).

Where does mildew usually grow in a home?

Molds can thrive on any organic matter, including clothing, leather, paper, and the ceilings, walls and floors of homes with moisture management problems (EPA). Mildew often lives on shower walls, windowsills, and other places where moisture levels are high (EPA). Mold may begin growing indoors when mold spores land on surfaces that are wet (EPA).

Can mold grow without moisture?

Molds gradually destroy the things they grow on (EPA). The mold spores will not grow if moisture is not present (EPA). There are many types of mold, and none of them will grow without water or moisture (EPA).

How soon should wet materials be dried?

It is important to dry water-damaged areas and items within 24-48 hours to prevent mold growth (EPA). If you clean up the mold but do not fix the water problem, the mold problem will most likely come back (EPA).

Can mold affect health?

Molds produce allergens, irritants, and in some cases, potentially toxic substances (mycotoxins) (EPA). Potential health effects and symptoms associated with mold exposures include allergic reactions, asthma, and other respiratory complaints (EPA). Inhaling or touching mold or mold spores may cause allergic reactions in sensitive individuals (EPA).

Should I run the air conditioner if I suspect mold in it?

EPA says not to run the HVAC system if you know or suspect that it is contaminated with mold (EPA). The HVAC system could spread mold throughout the building (EPA). Ask a licensed HVAC technician to inspect the system first.

Related

Need an HVAC check on an air conditioner you suspect has mold? Blume Mechanical Service (CAC-1822618) repairs, installs and maintains HVAC and refrigeration equipment in Pinellas, Hillsborough and Pasco counties. Call 727-330-9131.

Sources: U.S. Environmental Protection Agency — What is the difference between mold and mildew? (https://www.epa.gov/mold/what-difference-between-mold-and-mildew) · U.S. Environmental Protection Agency — A Brief Guide to Mold, Moisture and Your Home (https://www.epa.gov/mold/brief-guide-mold-moisture-and-your-home) · U.S. Environmental Protection Agency — What are ten things I need to know about mold? (https://www.epa.gov/mold/what-are-ten-things-i-need-know-about-mold)

Search Google for mold vs mildew difference