HVAC, explained
What size dehumidifier do you need (pints per day)?
A dehumidifier's size is usually listed in pints removed per 24 hours (ENERGY STAR). That rating is measured at test conditions, not at your room's actual conditions (ENERGY STAR). ENERGY STAR says the capacity you need depends on the size of the space and its conditions without dehumidification (ENERGY STAR).
Buying a dehumidifier starts with one number: its capacity, usually given in pints per 24 hours (ENERGY STAR). That number is useful, but it does not answer the whole question. This guide explains what the rating measures, what ENERGY STAR says about the capacity you need, and how to judge how damp your home really is. It also covers the change to the test conditions, so you can compare an old label with a new one. Treat the steps as planning tools before you buy, and check the labeling and manual for your own model.
What the pints-per-day rating means
A dehumidifier's size, or capacity, is usually measured in pints per 24 hours (ENERGY STAR). ENERGY STAR defines capacity as the water removed in one day at test conditions, reported in pints per day (ENERGY STAR).
The number is measured at test conditions, not at your room's actual conditions (ENERGY STAR). Read it as a starting point. It tells you what the unit removed in a test, and it does not say how many pints your room needs (ENERGY STAR).
Keep the rating with the model's paperwork so you can find it again when you compare units.
How ENERGY STAR says to estimate capacity
ENERGY STAR says the capacity you need depends on two factors (ENERGY STAR). The first is the size of the space that needs to be dehumidified (ENERGY STAR). The second is the conditions in that space without dehumidification (ENERGY STAR).
For a portable dehumidifier, ENERGY STAR says to use its charts to estimate the minimum capacity (ENERGY STAR). Open the charts on the ENERGY STAR page and compare them with your own room measurements.
Measure the room's length and width, and note its ceiling height. Write the numbers down before you shop, so you can compare labels against the same room. Think of the chart as a first estimate, then check it against what you actually see and smell in the space.
Judge how damp the space feels
ENERGY STAR describes a slightly to moderately damp space as one that feels damp and has a musty odor that may be intermittent (ENERGY STAR). Its very damp level is a space that consistently feels and smells damp (ENERGY STAR). Its wettest level is a space where walls or floors sweat, or where seepage is present (ENERGY STAR).
These levels are about what you can feel, smell and see. A musty closet and a dry bedroom in the same house may not match. Note the level for each room you plan to dry out.
Write a short line for each room: what it feels like, what it smells like, and where you have seen moisture. That note is useful when you talk with a contractor or compare chart results.
Why ratings changed under the new test
ENERGY STAR says portable dehumidifiers are now tested at 65 degrees F, rather than 80 degrees F (ENERGY STAR). It says the test was changed to cooler conditions comparable to a basement setting (ENERGY STAR).
ENERGY STAR says there is less water to remove in cooler air, which is why capacities have decreased (ENERGY STAR). It also gives a rough correlation between old and new capacity ratings, as of 2020 (ENERGY STAR).
Compare two labels only when you know which test produced each one. Write the test date next to each rating in your notes.
Using your old unit as a guide
If you are replacing an existing dehumidifier, ENERGY STAR says you can judge by how much water you empty each day (ENERGY STAR). That is not a sizing rule for a new purchase or a room (ENERGY STAR).
For a few days, note how much water the old unit collects. Empty it on the same schedule each day so the readings are comparable. Bring the notes with you when you look at new units.
Use the log as a clue for a replacement, not as a final answer. Pair it with the chart method and the room measurements from the earlier steps.
Set a timer and drain the water
FSEC says to place a dehumidifier on a timer so that it runs 3 to 4 hours per day (FSEC). A timer lets you set the run time in advance.
FSEC says draining the condensate to a sink is often the preferred option (FSEC). For a unit that drains by hose, check the hose connection and the sink location before you decide where the hose will go.
Look at the hose again whenever you move the unit, so the connection is where you left it.
Humidity, mold and fans
UF/IFAS Extension Sarasota County says dehumidifiers reduce a home's moisture, which can limit mold growth (UF/IFAS Extension Sarasota County). Moisture control is one part of keeping a home in good shape.
The same extension office says not to use fans if mold is present in the home, because fans can spread spores (UF/IFAS Extension Sarasota County).
Keep a record of where you see dampness, such as walls, floors or closets. Dated notes are easier to compare than memory.
Checking humidity after an outage
UF/IFAS Extension Sumter County says to check indoor humidity when power comes back on after an outage (UF/IFAS Extension Sumter County). Make that check part of your restart routine, before the dehumidifier is put back into regular use.
The same office says mechanical hygrometers are frequently in error (UF/IFAS Extension Sumter County). It says electronic meters tend to be more accurate, but they should also be calibrated (UF/IFAS Extension Sumter County).
Read the meter's manual for its calibration steps, or ask the manufacturer how to check it. Write the reading and the time you took it, so you can compare later.
When to get a professional involved
If a dehumidifier will not run, or a room stays damp after the unit has run, check the owner's manual first. Look at the unit's nameplate for its model details, and note them before you call anyone.
Ask the manufacturer for support on your model, or call a licensed contractor for an assessment. Bring your notes on room size, damp levels and water collected.
Blume Mechanical Service, licensed under CAC-1822618, repairs, installs and maintains HVAC and refrigeration equipment in Pinellas, Hillsborough and Pasco counties.
Frequently asked
What does pints per day mean on a dehumidifier?
It is the capacity, usually measured in pints per 24 hours (ENERGY STAR). ENERGY STAR defines it as the water removed in one day at test conditions (ENERGY STAR).
Does the rating tell me how many pints my room needs?
No. The rating alone does not say how many pints a given room needs (ENERGY STAR). ENERGY STAR says the capacity you need depends on the size of the space and its conditions without dehumidification (ENERGY STAR).
Why did dehumidifier ratings drop?
ENERGY STAR says the test was changed to cooler conditions comparable to a basement setting (ENERGY STAR). It says there is less water to remove in cooler air, which is why capacities have decreased (ENERGY STAR).
Can I use the water my old unit collected to choose a new one?
If you are replacing an existing dehumidifier, ENERGY STAR says you can judge by how much water you empty each day (ENERGY STAR). That is not a sizing rule for a new purchase or a room (ENERGY STAR).
What does FSEC say about running a dehumidifier on a timer?
FSEC says to place a dehumidifier on a timer so that it runs 3 to 4 hours per day (FSEC). Check the owner's manual for any limits on your model.
Are home humidity meters reliable?
UF/IFAS Extension Sumter County says mechanical hygrometers are frequently in error (UF/IFAS Extension Sumter County). It says electronic meters tend to be more accurate, but they should also be calibrated (UF/IFAS Extension Sumter County).
Related
- Dew point vs relative humidity explained
- Types of humidifiers: how each kind works
- Whole-Home Dehumidifiers in Florida: When You Need One, and What to Ask
Need help with humidity control on your HVAC system? Blume Mechanical Service (CAC-1822618) serves Pinellas, Hillsborough and Pasco counties, is brand-agnostic and can be reached at 727-330-9131.
Sources: ENERGY STAR — Dehumidifiers (https://www.energystar.gov/products/dehumidifiers) · ENERGY STAR — Dehumidifier Testing and Capacity (https://www.energystar.gov/products/dehumidifier_testing_and_capacity) · Florida Solar Energy Center (FSEC) — Mold Growth (https://energyresearch.ucf.edu/consumer/buildings/building-science-basics/mold-growth/) · UF/IFAS Extension Sarasota County — Mold Management in the Home (https://blogs.ifas.ufl.edu/sarasotaco/2024/10/30/mold-management-in-the-home/) · UF/IFAS Extension Sumter County — Was your power out? Check indoor humidity (https://blogs.ifas.ufl.edu/sumterco/2022/10/04/check-indoor-humidity/)